Ninth lesson of the Basic Design course at IID Perugia: with cuts and partial folds the flat surface rises and creates a pattern of light and shadow.
“The sun never knew how great it was until it struck the side of a building.” – Louis Kahn
The exercise
Each cut lets you partly fold a flap: the sheet doesn’t come off, it lifts. Repeating the gesture creates a geometric pattern. White paper, only light and shadow: the relief can be read thanks to raking light, as in the work of Matthew Shlian, Ron Resch and the cut and bend technique.
Materials and preparation
The usual base (white F4 with a black F2 in the centre). Cut a 14 × 14 cm white square and draw a grid with 3.5 cm cells on the back in pencil: this is the basic rule.
How to do it
Cut and score
In each cell the continuous line is a cut, the dashed line a fold. The cut never closes the shape.
Lift the flaps
Fold each flap upwards, always at the same angle: the black appears and the flap casts a shadow.
Raking light
Bring your phone’s torch close from the side and move it: the shadows lengthen and shorten, the pattern changes.

Find a rule
Example: flaps getting deeper from left to right, on a 4 × 4 grid, same shape and depths of 0.9, 1.5, 2.1 and 2.7 cm. The relief grows and guides the eye. Below, some compositions made by students in previous years.

How to assess the board
- Is the geometric pattern clear and consistent?
- Are all the flaps folded at the same angle?
- Does the relief work in raking light?
- Clean cuts, precise folds, no flap torn off?
Download the presentation
The full presentation of the lesson is reserved for course students and can be downloaded from the password-protected materials area.
Go to the course materials →← Previous lesson: Colour · Next lesson: Kirigami →
All lessons on the Teaching page.



