Home > Teaching > Basic Design > Surface modifications: cutting and moving a rectangle

Surface modifications: cutting and moving a rectangle

Cutting a rectangle and moving its parts: straight, diagonal, curved and broken cuts to discover new compositions.

Surface modifications, Basic Design lesson cover

Second lesson of the Basic Design course at IID Perugia: a rectangle of white paper, a few cuts and no waste. By dividing and moving the parts, solid and void together build rhythm and balance.

“Less is more.” – Ludwig Mies van der Rohe

The exercise

A flat surface is divided by detaching and moving its parts. The solid (the white paper) and the void (the black that appears between the cuts) work together. Cutting is already designing: Henri Matisse called his cut-outs “drawing with scissors”, and Lucio Fontana and the Bauhaus Vorkurs also worked with cuts.

Materials and preparation

We start from the base shared by all exercises: a white F4 sheet (33 × 48 cm) in landscape with a black F2 sheet (24 × 33 cm) glued in the centre, aligned with set square and ruler. A 15 × 10 cm rectangle is then cut from the white paper, measured with the ruler and cut with the cutter on the cutting mat: 90° corners and clean edges.

How to do it

01

Cut and move

A cut divides the rectangle into two parts: moving them apart creates a black line, a void that becomes part of the drawing.

02

More cuts, more rhythm

Each new cut changes the relationship between solids and voids. Distances are a choice: equal, increasing, alternating.

03

Try, then glue

Move the pieces without glue until it works, mark with a pencil, glue one piece at a time and clean the board.

The character of the cuts

Cuts can be straight, diagonal, curved or broken. Does the rectangle stay recognisable or change shape? You decide.

The golden rule: take nothing away, add nothing. All the pieces of the rectangle must stay in the composition.

Find a rule

A simple rule makes the composition consistent: the viewer recognises it. For example: strips 1, 2, 3, 4 and 5 cm wide (1 + 2 + 3 + 4 + 5 = 15) and increasing distances between the strips. The examples in the presentation show fifteen ways to cut the same rectangle, each with a single rule.

Fifteen examples of surface modifications of the same rectangle

How to assess the board

  • Is the composition consistent and harmonious?
  • Can you recognise a rhythm, a language?
  • Did you follow the rule: nothing removed, nothing added?
  • Are cutting and gluing precise and clean?
Food for thought for next time: look around you for a cut surface – a shutter, a grille, a façade, a perforated fabric – and photograph it. What rule did its designer follow?

Download the presentation

The full presentation of the lesson is reserved for course students and can be downloaded from the password-protected materials area.

Go to the course materials →

← Previous lesson: Introduction to Basic Design · Next lesson: The module →
All lessons on the Teaching page.

Shall we design your next product?

A quote, a question or just a hello: we’re always happy to hear from you.